5 inch Monitor with Custom HDMi Cable Rifle Mount for ATN X-sight Thor

Here is custom made water resistant micro HDMI 18 inch cable and monitor setup for older ATN X-sight and THOR thermal scopes. This is good for making scope hand held easy to view camera for finding game at night or sitting in blind. Monitor has all metal body and internal battery that will last for about 2 hrs of continuous use, or you can be powered/charge with any 12 DC volt source. The Monitor has NO speaker is NOT touchscreen and NOT water tight must be kept dry. The Mount slides and locks to any Picatinny rail and tilts and spins 180 degrees and is made of aluminium. The monitor has 1/4 -20 threads on side and bottom. PLEASE NOTE: I recommend permanent cable instillation to scope as the Micro HDMi connector dose not like to be unplugged and plugged in, it will fail after too many times if that. See 1st photo for all parts your getting. Dose NOT include scope, riffle, tripod etc. (Just showing how can be used) Screen still has protective plastic on it. There are no scratches on screen itself. This is a used monitor see pictures for condition and screen blemishes( Last picture ) Other photo's are just possible setups. NO RETURNS. There are 2 types of o-rings provided 2 soft rubber and 2 standard. Simply pull on o-ring to tell witch type it is. Remove protective caps from HDMi end (Don't trash you may need them latter) Test fit to see witch fit is preferred Note: The soft type o-ring my have to be held down for a few minutes till it forms to the the shape of scope threads. There is as small tolerance difference between the Thor scopes And X-sight fit may vary. Plug both cable ends in. Power on scope 1st then monitor. If at any time HDMi cable is unplugged you must power down monitor to reestablish sync. If No video... remove cable from both end dip both ends in Isopropyl (Rubbing) alcohol and the blow out ends with air. Do NOT pure alcohol in Scope and or monitor ends. Hdmi connecter must be kept dry and clean. Reboot monitor see if works. Also if no video remove 90 degree adapter and plug direct to monitor if works, 90 degree adapter my need cleaned or is bad. Hook up and retest. If no video Scope hdmi may have had previous damage or dirty. For permanent installation : Install SD card if you want to record video. You be able to play back in Gallery mode but must have Monitor/TV or PC that has HDMi input and can record, REinstall plastic caps !! on both ends of hdmi cable. Use 100% silicon glue. If you want to be able to remove at latter time Apply small amount glue all the way between o-ring and outer cap edge. Now remove plastic cap from micro end and install to scope. Maybe necessary to hold down connector till glue dries for best fit. Use rag or Q-tip to remove excess glue be for it sets up. Hook up retest Be careful not to get ANY glue on connector end. If this happens do NOT install to scope. Let dry 24 hrs and scape with razor. Then Retry Please Note: Monitor is not at ALL water/dust resistant if you plan on using in rain wrap in clear plastic bag like zip lock and rubber band were mount and cable go out. When using scope with out monitor install plastic cap on HDMi cable end then wrap cable around scope. See picture Returns NOT accepted NO Refunds